UTD-EM-T
UTD-EM-T

UTD-EM-T is an Ethernet inverse multiplexer with 4 x E1 (G.703 2048kbit/s) interfaces. It allows connection of Ethernet network using one to four E1 channels aggregating their band. Ethernet packages stream is divided into 4 E1 channels and then, in the second device, different E1 channels are multiplexed into one channel, where the main stream of packages is restored. By using 4 E1 channels, it is possible to obtain the maximum throughput of 8.192 Mbit/s for Ethernet packages. The malfunction of a single E1 channel, regardless of a direction, causes its automatic switch off and no loss of packages. In case the line is back in operation, such a condition is automatically detected by the device and the transmission in the channel is restored.

SPECIFICATION DESIGNATION LOCAL INTERFACE LINE INTERFACE
Ethernet over 4xE1 Inverse Multiplexer / Concentrator
​Ethernet, WWW, Telnet, SNMP, CLI management
UTD-EM-T 10/100 Mbit/s
Ethernet
4x E1
Ethernet over 4xE1 Inverse Multiplexer / Concentrator.
​Ethernet, WWW, Telnet, SNMP, CLI management.
Rack mount version
UTD-EM-T-RACK 10/100 Mbit/s
Ethernet
4x E1

 

Special features:
  • Connects Fast Ethernet LANs over up to four E1 line (8192 kbit/s )
  • Framed (G.704) and unframed E1 interfaces (selectable)
  • Two working modes: Multiplexer, bridges two LANs over E1 channels; Concentrator, collects traffic from different LANs connected by 1-4 E1 channels
  • Built-in four port Ethernet switch with an array of 1000 MAC addresses
  • Automatic E1 channel failure detection, removal and addition of E1 channels, smooth adjustment of Ethernet bandwidth
  • IEEE 802.1q support. Possibility of defining up to 15 VLAN networks (full range VID) in order to create independent transmission channels
  • Two synchronization modes: internal or external clock
  • Maintenance and Management: WWW, TELNET, SNMP, RS232 serial port
  • Local and remote E1 loopbacks
Technical specification:

PARAMETERS

Ethernet Ports

  • Baud rate 100/10 Mbit/s
  • Flow control function
  • ​Connection state signalling
  • 4 x RJ45 connector

Power supply

  • Supply voltage range 12 to 60V DC
  • External power supply included, 230VAC/48VDC
  • Up to 6W power consumption

Multiplexing

  • ​4x E1 channels
  • Maximum delay difference between E1 channels of up to 50 ms
  • Minimum loss of band in E1 channels for Ethernet frames of 1500 bytes < 1%

Line interface 2048kbit/s

  • Framed and unframed, G.703 and G.704 compliance
  • ​2048 kbit/s ± 50 ppm binary throughput
  • 120 Ohm E1 impedance
  • Line code HDB-3
  • ​RJ45 connectors

Dimensions

  • Housing: 103x230x53mm
  • ​Weight < 1kg